You Get Stuck In The Middle Of The Installation

Updated : 2019-07-08 03:53:33 UTC

Traget product: IJCAD 8 以降

If the installation of IJCAD would stop on the way, make sure the following points.


  1. ZIP file is not expanded (decompressed). 
    Download the installer file, the case was a ZIP file, it has become a state where the files required for the installation has been compressed. And would run the setup.exe not extract the ZIP file, because the other necessary file is not expanded, it will be in error, please run the setup.exe from to expand to any folder .

  2. Setup is not running with administrator privileges. 
    When you install the IJCAD, you must have Windows administrator privileges. If the promotion to administrative privileges in the PC environment is limited, please contact the administrator of the system.

  3. .Net FrameWork is not installed correctly. 
    IJCAD 2013/2014/2015/2016 In .Net FrameWork 4.x,
    requires .Net FrameWork 3.5 In IJCAD 8.
    In Windows XP, you will need to install because it does not have been introduced in the initial state.
    In addition, because it is that you may also be used in other programs, if the installation is if you quit in the middle, please try to re-install the Microsoft .NET Framework.

    Microsoft .NET Framework 4.x can be downloaded from the following site. 
    Microsoft.NET Framework 4.6

    Microsoft.NET Framework 4.5.2

    Microsoft.NET Framework 4.5(Windows7 SP1 以前の場合)

    Microsoft.NET Framework 4.0(Windows7 SP1 以前の場合)

  4. ハードディスクの容量が足りない。
    IJCAD のインストールに必要なハードディスクの空き容量が確保されているか確認して下さい。

  5. サポートされていない OS にインストールしようとしている。
    IJCAD の動作環境に記載されている以外の OS での動作については、対応できませんのでご了承下さい。


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request