Follow

How to undisplay the border of the image

Updated : 2016-10-27 02:00:00 UTC

Applicable Products : IJCAD 8 and later

 

If you do not want to display the border of the attached image, change the system variable as follows: 

  1. Key in the command line as follows,
    imageframe[Enter]
    Key in the new value of IMAGEFRAME <1>: 0 [Enter]

 

If you want to display the border, change "IMAGEFRAME" to "1".

 Left Picture : Display Border,  Right Picture : Undisplay Border

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments