Follow

IJCAD Mechanical data, can be opened in IJCAD?

Updated : 2017-04-04 02:34:04 UTC

Applicable Products : IJCAD Mechanical 2014 or lator.

 

IJCAD Mechanical data is the generic IJCAD (or AutoCAD) but it is possible to open.

However, please note the following points.

  • IJCAD Mechanical specific part of the figures that have been created in the function is the Proxy object in the case opened in IJCAD. (With a brief description of the Proxy object, the display is that it is the graphic can not be edited as it is is.) Proxy objects in many cases, but will be edited by decomposition, after decomposition, which does not have a function as a Mechanical to become a figure, updating and behavior of the data in conjunction with Mechanical specific figures it will not be performed.
  • Part of the Proxy data, if it is, will be stored while having the function of Mechanical.
  • In IJCAD Mechanical 2015/2016, DWG 2013 format, save in the form of a non-Mechanical 2013 DWG format is not recommended.

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments