Applicable Products : IJCAD 2013 and later
There is an editor command for block figure without decomposition, such as Block Editor (_BEDIT) and In-place Block Editor (_REFEDIT). You can use both commands in IJCAD 2013 and later version.
The difference between "Block Editor" and "In-place Block Editor" is as follows :
- Block Editor … You can open the block definition and edit the block. On PRO grade version, you can also execute the Dynamic Block definition.
- In-place Block Editor … You can redefine the External reference and Block watching the current drawing. But you cannot edit the Dynamic Block.
Refer to the following table to confirm each command supported version.
IJCAD | BEDIT | REFEDIT |
2013 LT / STD | × | ◯ |
2013 PRO | ◯ | ◯ |
2014 All grade | ◯ | ◯ |
2015 All grade | ◯ | ◯ |