Applicable Products : IJCAD 2013 and later
In order to create ellipse by polyline, it is necessary to change the system variable of figure type created by ellipse command.
Follow the next procedure.
- Key in "ELLIPSE[Enter]" in the command line.
- Continue to key in as follows :
Input the new variable of PELLIPSE<0>: 1[Enter] - When you execute ellipse command and create the ellipse as usual, created ellipse will become polyline.
If you want to revert to the original status, set "PELLIPSE = 0".
Reference Image
Current ellipse, which has already created, does not change its attribute. The figure created after changing the PELLIPSE setting, keeps the dwfined attribute.