How to control the hatching position

Updated : 2018-01-24 02:47:10 UTC

Applicable Products : IJCAD 2014 / 2015 / 2016


When the hatching display position is necessary to tune, try the next command.  

  • Set the origin point(_hatchsetorigin)


When you execute the command, first select the target hatching to move, then click right button of the mouse and select "Set the origin".


The reference video is as follows :


Even in some of the old version of IJCAD, the hatching edit might be possible.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request