About The Transition From A Trial To a product version

• Depending on the timing, than the installed trial version, towards the retail version is also available if the new. In principle, the trial version after uninstallation, why it is better for you to install the product version.

• In the case of stand-alone license

From a trial to a product version it is possible to change the serial key.
Without uninstall, you can migrate to a product version.

Please refer to the following procedure.

1. Start IJCAD.
2. At [IJCAD License Management dialog box
   , select the "stand-alone", please click [OK].
   
3. In [user information confirmation dialog, enter the user information.
   The serial key you received at the time of purchase in the serial key] of [product information]
   that receive input you, you will be asked to use it as a product version.
   * until the license authentication is complete will start as a trial version
4. On the setup manual of reference, please go to register the license.
   (Online registration → P.9 "stand-alone version (online)" procedure ② later
   　mail registration → P.10 "stand-alone version (e-mail application)" procedure later ②)

• In the case of network license · USB license

It can not be used to change the serial key to a product version from a trial.
Once the trial version to uninstall, please go the new product version of the installation of.

It can not be used to change the serial key to a product version from a trial.
Once the trial version to uninstall, please go the new product version of the installation of.